Specifications
85″L x 33.9″W x 53.3″ H; 456 lbs.
Being indirect-fired, they can be operated indoor and can also be ducted.
The Phoen 400 Series Indirect Fired Mobile Space Heater and is commonly used for localized heating in workshops, foundries and construction. Therefore the unit also lends itself to certain horticultural and agricutural applications. The PHOEN heaters feature a heat exchanger that contains the flame and expels fumes throughout a chimney connected to the outside. Being indirect-fired, they can be operated indoor and can also be ducted.
Service Manuals:
BM-PHOEN-N-380-Service-Manual
L-L106.01-BM-PHOEN-400
– CSA approved for construction US-C
– Separated burner blower
– Two-stage dedicated burner (low and high fire selector)
– No supervision required: can be controlled by thermostat, humidistat or timer
– 1 ft power cord
– AISI 430 stainless steel combustion chamber with four-pass heat exchanger technology
– Convection fan is controlled by thermostat that measures combustion chamber temperature
– Combustion chamber pre-heating cycle
– Electronic flame control unit
– Combustion air pressure switch (safety device: turns off the unit and requires a manual reset)
– Fuel lines in hydrocarbon-resistant rubber wire mesh protected
– Overheat thermostat
– Bayonet-type fuel tank cap
– Fuel tank drain plug
– Ventilation only mode (fan can be operated when the burner is off)
– Pre-heated oil filter
– Anti-shock frame with foldable handle
– Single point lift bail and forklift pockets
– 16” pneumatic wheels (16” for HC version)
– Optional return air adapter for inside warm air recirculation
– Heater is shipped fully assembled
– Single fuel line kit: allows recirculating hot oil from the return line back into the preheated filter. This helps cold starts and better burning performance in extremely cold temperature
SPECIFICATIONS
<strong>Cantherm Phoen 400 Diesel 02EC260</strong>
Weight: 456 lbs
BTU (input): 411,905 (stage two) / 272,189 (stage one)
Efficiency: 86% (stage two) / 85% (stage one)
CFM: 3,250
Tank Capacity: 57 gal
Fuel Use: 2.97 gal/h (stage two) /1.96 gal/h (stage one)
Run Time: 19 hr (stage two) / 29 hr (stage one)
Power: 120 V / 1 ph / 60 Hz
<strong>Cantherm Phoen 400 GAS 02EC260</strong>
Weight: 456 lbs
BTU (input): 380,548
Efficiency: 86.5%
CFM: 3,250
Tank Capacity: No Tank
Fuel Use: 356 chf NG
Power: 120 V / 1 ph / 60 Hz
| Weight | 375 lbs |
|---|---|
| Dimensions | 47 × 74 in |
| Select Diesel or Gas Model | PHOEN 400 Diesel, PHOEN 380 Gas* |
Shipping cost displayed is to a commercial location within city limits with a dock or forklift. Otherwise additional shipping charges may occur. Optionally, we can ship to your closest freight depot for Will Call and they can load it into your vehicle.