Cantherm 200K BTU Indirect Fired Heater EC200
The Cantherm 200K BTU Indirect Fired Heater EC200 delivers 219K BTU. It comes standard with a preheated oil filter improving cold starts. A wide range of adapters and ducting options are available. Cantherm is also known as Arcotherm
- Built in oil burner
- Electronic flame-control system
- Safety overheat thermostat and pressure switch
- Outlet for remote thermostat
- Double Skinned combustion chamber for thermo-acoustic insulation and safe low surface temperature
- Pre-heated oil filter (except EC 100)
- Unique two-stage startup to prevent cold starts
- Pre-purge and post-ventilation cycles
- Twist-lock tank cap with leash
- Stainless Steel Heat Exchanger with the Four Loop Exhaust System
The 200K BTU Indirect Fired Heater has a four loop exhaust system
This 200K BTU Indirect Fired Heater is built using a proprietary four loop exhaust system that results in higher efficiencies and heating power than the traditional three loop system used in most heaters:
- Comes standard with a four-loop heat-exchanger, providing a longer path for exhaust gases to release their heat before exiting through the chimney. The end result is a 2% increase in efficiency over the performance of the traditional three-loop heat-exchange
- Hot gas passages between the EC Series firebox and exchanger are exposed to lower temperatures, pumping up the heater and gaining an additional 10% in heating power compare to three loop units with the same size
SPECIFICATIONS for the EC200
BTU: 113,000
Field Consumption (GPH): 1.56
CFM: 1530
Duct Length (ft.): 50
Dimensions (LxWxH in.): 47x20x37
Weight : 176 lbs
Duct Diameter (in.): 12
Tank (gal.): 17.2
Power Supply: 110V
11/12/2019