Showing 21–40 of 83 results

Product Listings

400k BTU Propane and Natural Gas Heater
– CSA US Certified. MEA approved for NYC
– Fan: 2000 CFM 1/4 HP, – 115 Volts 12 amp
– 44″ L x 16.5″W x 22″ H; 95 lbs.
FREE SHIPPING to commercial location in continental US and Canada
$2,245.00
– 110,000 BTU/HR
– Indirect-Fired Fan: 120v, 4amp; CSA US Certified
– Air Flow: 880 CFM; Ductable up to 25′
– Fuel: Diesel, Kerosene, Fuel Oil, JP-8, Jet A
– Fuel Tank: 12 US Gallons,xa0 Pre-Heated Fuel Filter
– Shipping Size: 38″L x 22″W x 25″H, 100 lbs.
– Could heat 20’x40′ tent, (30 deg. temp rise)
$2,225.00
Sale!

– Cantherm EC 100 Heater including Adapter and 25′ Duct
– Air Flow: 880 CFM; Heat Rise 150 deg. F.
– .81 GPH; 11.9 Gallon Tank; 110 V
– Preheated fuel filter standard.
– 11″ x 25″ Duct Included with Adapter

$2,019.00 $1,729.00
Sale!
Stock subject to change without notice.
Please inquire before ordering. Thank you.

– BTU/hr 400,000, – CFM 2,500
– 120 Volt, 60 Hertz, 12 Amp Single Phase
– Air outlet: 15′ Diameter
– 48′ Long x 22′ Wide x 24′ High; 90 lbs
– Regulator Extra
$1,772.00 $1,590.00
Sale!

– Cantherm EC 100 Heater
– Air Flow: 880 CFM; Heat Rise 150 deg. F.
– .81 GPH; 11.9 Gallon Tank; 110 V
– Preheated fuel filter standard.
– Uses 12″ x 12′ Pin-Lock Duct, No adapter needed
10% OFF Order Two or More Units Coupon code EC10%Off

$1,599.00 $1,399.00
Sale!

– Similar to 18E-1 but w three-phase
– BTU/Hour: 65,000, 590 CFM
– Watts: 18kW / Air Flow: External Fan
– Volts / Amps: 240V / 47A
– Size: 32″x1 4″x 20″; 62 LBS

$1,395.00 $1,293.00
Sale!

Stock subject to change without notice.
Please inquire before ordering.
– 85,000 BTU; 450 CFM
– Propane or Natural Gas; Thermostatically controlled
– 115V/60Hz/1PH/15Amp; Direct Spark Ignition Control
– Operates as a fresh air circulator
– 30″ Long x 16″ Wide x 22″ High;  135 lbs

$1,347.00 $1,290.00
Sale!

Stock subject to change without notice.
Please inquire before ordering.
– 85,000 BTU
– Thermostatically controlled
– Operates as a fresh air circulator
– Warnock-Hersey Approved
– Direct Spark Ignition Control
– 450 CFM heated air output ; 135 lbs

$1,273.00 $1,190.00

– Similar to 18E-3 but w single-phase
– BTU/Hour: 65,000, 590 CFM
– Watts: 18kW / Air Flow: External Fan
– Volts / Amps: 240V / 47A
– Size: 32″x1 4″x 20″; 62 LBS

$1,186.00
– 8 in. diameter x 25 ft. length.
– Wire helix reinforced with anti-scuff strip.
– Complete with aluminum attachment cuff and static ground leads.
– For use with the Model EP8HL Blower only.
$751.00
Sale!

– Electric Motor: 1/4HP, 115 VAC, 60 HZ
– Variable up to 500 CFM (14.2 CMM) flow rates
– 1st Stage Standard: 18 x 18 x 1 inch pleated media, 30%
– 1st Stage Optional: 18 x 18 x 1 inch activated carbon
– 2nd Stage: 18 x 18 x 2.5 in. pleated HEPA, 99.7% @ 0.3 microns
– Accessory Power: Integral, 15 Amp GFCI duplex/12 Amp breaker

$795.00 $745.00

– HD Frame Kit for Cantherm Phoen 380/400 Indirect Fired Heater.
– Heavy frame with lift ring
– 360 degree protection and pallet fork pockets.

$700.00
Sale!
!!! IN STOCK !!!  OK TO ORDER NOW. 
Shipping extra. OK to order online without shipping.
– 30,700 BTU/HR – Electric Heater
– A 240V unit requires 40Amp circuit, runs on 25A
Plug into a dryer or stove outlet
– 9kW / 240V – 30,700 Btu/Hr
– Cord: 10 ft / Plug type: NEMA 14-50P
– UL Approved, 39 lbs.
$656.00 $624.00

16″ x 15′ EnviroDuct PVC Ducting and Adapter Kit
for Cantherm EC Heaters

16″ x 15′ EnviroDuct PVC Ducting for Cantherm EC Heaters
– Temperature range:
-20 to 200 degrees F; -29 to 93 degrees C
– Standard Pitch: 6″ dia.- 3″ pitch; 8″, 11″- 4″ pitch.

$498.00
Out of stock
– 20,500 BTU/Hour;   250 CFM
– Watts 6,000 /Amps 240V / 25A / Single Phase
– Thermostat 32xb0F u2013 100xb0F
– L x W x H – 20″ x 12″ x 17″   32.9 LBS
– Distributor is Out of Stock for the 2018-19 Heating Season
$492.00
– 8 in. diameter x 15 ft. length.
– Wire helix reinforced with anti-scuff strip.
– Complete with aluminum attachment cuff and static ground leads.
– For use with the Model EP8HL Blower only.
$475.00
– HWAG-23189
– Heatwagon Diffuser
– 15lbs
$442.00
Sale!

– Accessories for Indirect-Fired Heaters
– 16″ x 25 Hitex Ducting for Flagro indirect heaters
– Non-insulated, Durable

$410.00 $390.00
– PHOEN380 Three Way Duct Adapter – 12″
– Splitter for Phoen400 heater to accept three 12″ x 15′ ducts.
$373.00
ACCESSORIES for HVF110
– Heatwagon 12″ x 25′ Ducting
-12 Inch x 25 Foot Ducting
$359.00